Hello, I was reading the Help file on Probe commands and read the following:
CL Command Issued
VERIFY / PNT [, CLEAR, a] [, PERMIN, b] ( ,OSETNO, c )
OSETNO, c
Indicates the difference between target point and measured value. This difference will be placed in register u201ccu201d. No impact on probe motions.
i cannot find anymore information about this "register u201ccu201d". Anyone any experience with this?
The goal of this all is off course to be able to measure my casting work piece and then let the nc program let it's coordinates adjust to the measured values. I'm still researching if it is possible or not.. I suppose it is, because a casting work piece is never twice the same, so i suppose a post processor should be able to interpret this verify command for its probing cycles.