We are about to upgrade to Creo2 M030 and EMX 7 M030 from WF2.
I have had Creo1 M040 installed with EMX 7 F000 since last year and as we
were testing we found it very unstable and then we got busy and had to leave
it until now.
Any advice will be appreciated but specifically is there anything we should
know about bringing up legacy data for mould designs and mould splits from
WF2 EMX 4.1?
Running both Win XP SP3 32 bit and Win 7 64 bit
Best regards,
Steve Cooke
Cooke & Son Manufacturing cc
Managing Director
+27 31 7010155
I have had Creo1 M040 installed with EMX 7 F000 since last year and as we
were testing we found it very unstable and then we got busy and had to leave
it until now.
Any advice will be appreciated but specifically is there anything we should
know about bringing up legacy data for mould designs and mould splits from
WF2 EMX 4.1?
Running both Win XP SP3 32 bit and Win 7 64 bit
Best regards,
Steve Cooke
Cooke & Son Manufacturing cc
Managing Director
+27 31 7010155