I created a cross section of a mold assembly and it appears
to have no errors. When I entire DETAIL mode and attempt to
place that view (front) on my sheet I get an error message
"Cross-section creation in view "new_view_1", on sheet 1, aborted"
any ideas what the problem could be and where I might look
to correct it?
I don't have any geom checks and in assembly mode the section
appears to have no problems.
Thanks in advance.
to have no errors. When I entire DETAIL mode and attempt to
place that view (front) on my sheet I get an error message
"Cross-section creation in view "new_view_1", on sheet 1, aborted"
any ideas what the problem could be and where I might look
to correct it?
I don't have any geom checks and in assembly mode the section
appears to have no problems.
Thanks in advance.