Hello~~
I have couple suggest about Lathe function of Creo manufacturing, please refer to below suggestion, thanks!!
- I have set up "Home point" and "From point" at “Operation” dialog window, but those points can’t automatically copy to each sequence for start and end position. For the reason, users need to select the start point and the end point every time when they create sequence. If PTC can resolve it then users can save some steps from doing the same thing, because the setting of start and end points is very important in lathing function. (車床功能的Home point跟From point可以自動copy到每個sequence的Start point and End point，那就更方便了，因為Home點與From點大部分都是固定的，如需要變化可再自行做修改即可。)
- As we know the tool parameter (cut data) can be stored on “work center”, and those data can automatically copy to parameter window. This function is very useful for NC users. If PTC is willing to add “TOOL_ORIENTATION, START_MOTION and END_MOTION on “tool setup” dialog window, as shown below illustration. Currently, after tool selection, users need to set up parameters which are mentioned in previous every time when they create sequence. (Work center可以存儲刀具這個功能真的很棒，如果可以再把Tool_Orientation(定向)、Start_motion and End_motion都可以在選擇刀具時去做定義，那使用者就不需要在每次製作Sequence時最重複的動作。)
Mark Rao
訊息由此人編輯：Mark Rao