I would like to know how to turn on 3D Cutter Compensation in Pro/NC. Here
is what is output to the NCL file when it is enabled:
MODE / 3DCOMP, ON
...
CUTCOM / ON
GOTO / 24.4070718118, -11.0963791260, -8.2054735622, $
0.2054965047, -0.2582157475, 0.9439787150, $
0.5364531275, -0.2645786937, 0.8013839011
GOTO / 24.8306712658, -9.7398669112, -8.0725117395, $
0.2054965047, -0.2582157475, 0.9439787150, $
0.5205224109, -0.2254581166, 0.8235442049
Thanks,
Fred Nemecek
Austin N.C., Inc.
512/458-1112 x19
is what is output to the NCL file when it is enabled:
MODE / 3DCOMP, ON
...
CUTCOM / ON
GOTO / 24.4070718118, -11.0963791260, -8.2054735622, $
0.2054965047, -0.2582157475, 0.9439787150, $
0.5364531275, -0.2645786937, 0.8013839011
GOTO / 24.8306712658, -9.7398669112, -8.0725117395, $
0.2054965047, -0.2582157475, 0.9439787150, $
0.5205224109, -0.2254581166, 0.8235442049
Thanks,
Fred Nemecek
Austin N.C., Inc.
512/458-1112 x19